Getting Started with SignMaster Pro 3.5: A Step-by-Step Guide

If you have recently purchased a Vinyl Systems cutter and are looking to get started, this guide will walk you through the process of setting up your machine and software. The setup process for all Vinyl Systems cutters of the Specialist, Edge, and Evo lines is nearly identical, with only a few extra or differing steps for each machine.

Adjusting the Force and Speed Settings

Before we begin, it's essential to adjust the force and speed settings on your cutter. To do this, use the left and right arrow buttons to set the force to 90 grams, and the up and down arrows to set the speed to 400 millimeters per second. Once you have made these adjustments, use the blade holder's golden ring to lock them in place.

Loading the Blade

Next, unload the cutter's blade and adjust it by twisting until it is as tall as a paper's thickness. This will ensure that your blade is properly seated and ready for cutting.

Connecting Your Cutter to SignMaster Pro 3.5

To connect your cutter to SignMaster Pro 3.5, go to the Connection tab in the software and change the Port Type to Direct COM Port with the Port Name set to USB-SERIAL. If you are using a Specialist cutter, you may need to select the correct port type and name.

Installing the SignMaster Software

The first step in setting up your Vinyl Systems cutter is to install the SignMaster Pro 3.5 software. This can be done by downloading the installer from the Vinyl Systems website and following the prompts. You will need to enter your activation code when prompted.

Configuring Your Cutter's Properties

Once you have installed the SignMaster software, it's time to configure your cutter's properties. To do this, go to the Select Model section in SignMaster Pro 3.5 and select your Vinyl Systems cutter from the list of available models. Click the Properties button to access the cutter's settings.

Sending a Test Cut

Before you can begin cutting, you need to send a test cut to your cutter. To do this, click the Send to Cutter icon on the top toolbar in SignMaster Pro 3.5 and select the blade icon. This will send a test cut to your cutter, allowing you to check that it is properly calibrated and functioning correctly.

Getting started with your Vinyl Systems cutter and SignMaster Pro 3.5 software is a straightforward process. By following these steps, you should be able to get your machine up and running quickly and easily. Remember to adjust the force and speed settings on your cutter, load the blade properly, and configure your cutter's properties in SignMaster Pro 3.5. With these basics covered, you'll be ready to start cutting with confidence.

Signmaster pro 3.5